How to connect solar panel to battery – MPPT Solar Charge Controller

In my last post, I have written about the connection of solar cells to batteries, in this post you learn about ” how to connect the solar panel to battery with MPPT (maximum power point tracking) solar charge controller. The post provides you with the complete installation of the solar panel charge controller and battery connection.

 

How To Connect Solar Panel To Battery With Charge Controller?

The connection of the solar panel to the battery and installation of a charge controller is too easy wiring connection but a new person always wants a guide to doing this installation. This too an easy connection which can be done by anyone.
The complete method of wiring solar panels to an MPPT charge controller and battery connection is too simple steps.

  • First of all, connect the negative and positive wires of the solar cell to the charge controller solar panel’s negative and positive input terminals.
  • Then do connection between the battery and the charge controller.
  • The 3rd step is not to use too much however if you want to use some DC (direct current) devices from the solar charge controller then get connected from the solar charge controller for your dc load.

Note that in the below diagram I have shown the negative with black colour and the positive with red colour lines.

All steps are incomplete before a diagram and note that above all steps do regarding the below solar charge controller diagram.

Solar Charge Controller Diagram

Follows the above method of wiring or connecting a solar to a battery as shown in the above solar panel wiring diagram.
I hope after this diagram you will completely understand and you will be able to do the connection without any person’s help.

 

Leave a Reply

Your email address will not be published. Required fields are marked *